[GH-ISSUE #420] Diffiult to set/maintain fan speed #378

New issue

Closed

opened 2026-02-26 00:32:28 +03:00 by kerem · 1 comment

kerem commented

2026-02-26 00:32:28 +03:00

Owner

Originally created by @Em125 on GitHub (Jan 6, 2018).
Original GitHub issue: https://github.com/hirschmann/nbfc/issues/420

I have an HP Zbook G2 and run Windows 10.

I am having a hard time with setting the fan speed, the cursor will automatically shoot back to 100% no matter how much I try. Once in a while it will "stick" and when it does it works well for a couple of hours at most then the fan speed will go all the way too 100% again.

A temporary measure I've found was to switch to "read-only" for a little bit, or to switch to a different configuration but nothing proves consistent. if there's an incompatibility I don't know what it could tem from. Any advice?

Originally created by @Em125 on GitHub (Jan 6, 2018). Original GitHub issue: https://github.com/hirschmann/nbfc/issues/420 I have an HP Zbook G2 and run Windows 10. I am having a hard time with setting the fan speed, the cursor will automatically shoot back to 100% no matter how much I try. Once in a while it will "stick" and when it does it works well for a couple of hours at most then the fan speed will go all the way too 100% again. A temporary measure I've found was to switch to "read-only" for a little bit, or to switch to a different configuration but nothing proves consistent. if there's an incompatibility I don't know what it could tem from. Any advice?

kerem

2026-02-26 00:32:28 +03:00

closed this issue
added the
Stale
label

kerem commented

2026-02-26 00:32:28 +03:00

Author

Owner

@github-actions[bot] commented on GitHub (Dec 4, 2019):

This issue is stale because it has been open more than 180 days with no activity. If nobody comments within 7 days, this issue will be closed

@github-actions[bot] commented on GitHub (Dec 4, 2019): This issue is stale because it has been open more than 180 days with no activity. If nobody comments within 7 days, this issue will be closed